Fanuc Parameter 1860 Work -

If Parameter 1860 is set to a very small number (increasing electronic gearing ratio), the machine might become highly sensitive and vibrate or "hum" because the control is trying to manage too high a resolution for the servo loop.

: Detection unit (typically microns or 0.0001 inches, depending on the system's increment settings) en.industryarena.com How It Works When a machine is equipped with Absolute Pulse Coders (APC) fanuc parameter 1860 work

To edit it, you must be in MDI mode and have Parameter Write Enable (PWE) set to 1. If Parameter 1860 is set to a very

Parameter 1860 was a numeric thing, two bytes with a simple range. It should have been boring: a timer, a mode selection, something inexcusably practical. But its value read 0.00023. Ridiculous precision. Ridiculous because, on this model, values were normally integers. Ridiculous because the arm's movement, by all rights, should never have been affected. It should have been boring: a timer, a

Set back to 0 and clear any remaining alarms using [RESET] . Related Parameters