Din - 6935 Standard Pdf

It is recommended to bend transverse to the rolling direction whenever possible to avoid cracking and ensure a higher-quality bend.

2017

For leg lengths up to 30 mm, a deviation of ±2∘plus or minus 2 raised to the composed with power is allowed. This tightens to ±1∘plus or minus 1 raised to the composed with power for leg lengths over 120 mm. Bending Radii: Deviations range from +0.5positive 0.5 mm (for thin S235cap S 235 sheets) to +3.0positive 3.0 mm (for thick S355cap S 355 Accessing the PDF Din 6935 Standard Pdf

: Recommends a series of radii (e.g., 1, 1.2, 1.6, 2 mm) to promote uniformity across manufacturing tools.

The standard uses a specific formula to determine the flat blank size required before bending: compensation value that accounts for material stretching. Compensation Values ( It is recommended to bend transverse to the

Please note: and superseded by the international standard DIN EN ISO 13722 . This report reflects the historical relevance, technical content, and the transition to the current standard.

The DIN 6935 standard specifies the following requirements: Bending Radii: Deviations range from +0

The standard specifies the minimum permissible bending radius based on the material's thickness (